内蒙古快3走势图

Welcome to Huaxi science and technology website

冷压端头|接线端头|尼龙端头|绝缘端头

Power manufacturer of cold press terminal
Providing high quality products and services for the vast number of users

Hotline 400-0577-117
Current location:Index > News > FAQs >

National identification standard for copper terminals

Part of the article:未知 Popularity:发表时间:2018-06-20

This standard is equivalent to the international standard IEC 455 (1988) "General requirements for the identification and application of alphanumeric systems for terminal blocks and specific wire ends of equipment."


1 Topic content and scope of application


This standard specifies various methods of identifying the terminals of electrical equipment (hereinafter referred to as equipment), and formulates the general rules for identifying equipment terminals and specific wire ends using an alphanumeric system. This standard applies to identification marks of the terminals of equipment (such as resistors, fuses, relays, contactors, transformers, rotary motors, etc.) and combinations of these devices, and also applies to the identification of specific wire ends. When necessary, detailed application of these general rules for certain products and necessary auxiliary identification methods can be given in the relevant standards.


2 Reference standards


GB 4728 Graphical symbols for electrical drawings GB5465 Graphical symbols for electrical devices


3 Identification method


One or more of the following methods can be used to identify the device terminals and specific wire ends. 3.1 The marking system of the relevant product is used to determine and identify the actual or relative position of a device terminal or a specific wire end. 3.2 Use the marking system of the relevant product to identify and identify the color markings on the device terminals and on the ends of specific wire ends. 3.3 Use the graphic symbols specified in GB5465. If auxiliary symbols are used, they should be consistent with the figures in GB4728. 3.4 Use the alphanumeric symbols specified in chapter 5 of this standard.

Next:Use of copper terminal blocks Previous:none
内蒙古快3 内蒙古快3 内蒙古快3 内蒙古快3走势图 百盈彩票平台 内蒙古快3走势图 118彩票 166彩票平台 118彩票 159彩票